Cylinder will then pull out.
Lock on screen door not working.
Firstly for a whitco mk ii tasman lock the lock needs to be in the locked position.
You have a broken wire.
Check if it helps.
If thats the case it still might be possible to replace the mortise style lock that was originally built into the door.
For other types of problems with door knobs and locks please see repairing door knobs hardware.
No it s all aligned the latch goes through the hole in the strike plate nicely once the auxiliary bolt is pressed.
Pry up on it until it comes loose and remove it.
This may be caused by the latch plates.
Shut the door and try to lock it.
An improperly functioning latch may be the result of a poorly fitting door.
The lock and strike plate were installed new yesterday.
To do this when door is open you will need to press the deadlatching pin which sits above the main latch next you will need to undo the cylinder retaining screw then insert and turn key to lock position.
If the lock isn t getting power hold the lock switch either up or down and then open and close the door repeatedly to see if the lock will work.
Refer the link below for safe mode steps.
If your door key doesn t work right the first and most obvious step is to be sure you re using the right key.
Some screen doors have no clearance at all.
If it works sometimes you probably have a broken wire.
Door key does not work.
The lock mechanism may not work simply because the lock is dirty or dry and needs to be lubricated with graphite do not use any type of oil because this will gum up the works.
T s possible the door may not be aligned properly now so the latch is missing it s hole.
Tap the end of a chisel under the door stop on the striker side of the jamb.
Check in safe mode and clean boot.
Sometimes this just takes patience.
They work fine if you have room between the sliding door and the screen door.
Sorry that we feel the need to state the obvious assuming that you re using the right key keep working it until it turns the lock.
If not proceed to the next method.
When your screen door won t latch properly and pops back open or does not close all the way the latch plate is in the wrong position on the doorjamb.